Battleground Games Forum

Miniature Games => Warmachine / Hordes => Topic started by: shwnlyns on July 19, 2013, 10:04:42 PM

Title: assembly
Post by: shwnlyns on July 19, 2013, 10:04:42 PM

So I bought some Khador rifle corps but I cannot for the life of me figure out what arm goes with what model. Is there any good way of figuring this out?

Title: Re: assembly
Post by: the_trooper on July 20, 2013, 12:31:29 PM

I never built rifle corps but I have assembled too many 3 point connection models than I would care to admit.

Normally, my approach is to clean all the pieces from flash, then lay them out, dry fit each, dry fit again until you find the best combination. Once each "best combination" is met for each body, you should have all of your bodies with the right arms / guns.

If this makes you nervous, go to home depot and get some acetone and the right safety equipment as that's the easiest way to fix pewter mis-glues.

Title: Re: assembly
Post by: GossWeapon on July 22, 2013, 01:34:42 PM

lolno

Title: Re: assembly
Post by: shwnlyns on July 29, 2013, 12:52:20 PM

well that was a pain in the ass but finally, after finding some free time this month the rifle corps is assembled.
Thanx trooper for the advise, my trial and error efforts took some time thanks to poorly molded figures but it all came together in the end.